CEMENT
70 mm
m
m
05
-0
4:r
et
e
mai
D
WASHER
NUT
SPRING WASHER
MOUNTING PLATE
Mounting plate
Installation:
1. Unscrew the mounting plate and take it off. (Fig. 1/Fig.2)
2. Drill a hole as the instruction. Then put into the bolt and fix it with cement. (Fig.3)
3. Hanging on the mounting plate and ensure fix it. (Fig.4)
4. Installing the machine onto the mounting plate and ensure the safety,
than fix it tighten with screws. (Fig.5)
During installing the unit, please pay special attention to the following points in order to obtain the ultimate efficiency.
1. Install on solid place to avoid vibrations when machine is running and also for safety reason unnecessary noise
caused by vibration can be prevented.
2. AIR CURTAINS are used for indoor purpose.
3. Depending on the height to choose the most suitable model. If it fixed too high, the shut-off distance will be affected
then the efficiency will be reduced.
4. The air is drawn in front of the unit and is blown out downwards.
5. Several units can be mounted next to each other when wide door opening occur. Under such condition, a narrow
space in between 20-40 mm may happened.
6. During installation, the mounting plate should not have a gap between the walls.
Cautions / installations:
6
7. The distance between the unit and the ceiling
must reserve at least 30mm.
8. The unit is installed horizontally.
9. Recommend installing the machine at the
height of at least 2.3M above the ground.
10. A triple pole switch should precede the ap
pliance with at least 3mm breaking gap.
