3.
Installation
Main Part of Intercom Back Panel Wall-mounted Shell
Figure 1
Three Major Parts of i30
Step 1: Installation preparation
A.
Check the following contents:
Hex wrench x 1
RJ45 plugs x 2 (1 spare)
KA4 x 25mm screws x 4
25mm
screw anchors x4
B. Tools that may be required:
Hex wrench
Phillips screwdriver (Ph2 or Ph3), hammer, RJ45 crimper
Electric impact drill with an 6mm drill bit
Step 2: Drilling
Figure 2 Wall Mounting
A. Place the mounting template with dimensions on the surface of a wall in a desired flat position.
B. Use an electric drill to drill the 4 holes marked on the mounting template. It is recommended to drill about
30mm deep. Remove the template when you finished drilling.
C. Push or hammer screw anchors into the drilled holes.
Step 3: Removing hanging shell
A.
Remove the hanging shell as shown in Figure 3 and Figure 4.
