[
键入文字
]
10
/ 51
III.
Basic operation
1.
Answer a call
When a call comes in, the device will answer automatically. If you cancel auto answer feature and set
auto answer time, you will hear the bell ring at the set time and the device will auto answer after a
timeout.
2.
Call
Configure shortcut key as hot key and setup a number, then press shortcut key can call the
configured number.
3.
End call
Enable Release key hang up to end call.
4.
Open the door operation
Through the following seven ways to open the door:
1)
Input password on the keyboard to open the door.
2)
Access to call the owner and the owner enter the remote password to open the door.
3)
Owner/other equipment call the access control and enter the access code to open the door. (access
code should be included in the list of access configuration, and enable for remote calls to open the
door)
4)
Swipe the RFID cards to open the door.
5)
By means of indoor switch to open the door.
6)
Private access code to open the door.
Enable for local authentication, and set private access code. Input the access code directly under
standby mode to open the door. In this way, the door log will record corresponding card number
and user name.
7)
Active URL control command to open the door.
URL is “http://user:pwd@host/cgi-bin/ConfigManApp.com?key=F_LOCK&code=openCode”
a.
User and pwd is Web the user name and password.
b.
“openCode” is the remote control code to open the door.
Example: “http://admin:[email protected]/cgi-bin/ConfigManApp.com?key=*”
If access code is input correctly, the device will play sirens sound to prompt access control and the
remote user, while input error by low-frequency short chirp.
Password input successfully followed by high-frequency sirens sound, while input error is followed by
