18
Fixing the chronothermostat to the base
Fix the chronothermostat to the base by manual pressure, making sure that the multi-pole
connector is inserted correctly. The chronothermostat connection is snap-in.
Configuring the chronothermostat
Note
: Configuration must be performed only by qualified personnel.
By configuring the chronothermostat one can personalise its operating parameters. To
access the configuration programme, proceed as follows.
1. Press the SET / PROG key [key 6]. The current mode of operation is temporarily
interrupted and is resumed automatically when programming ends.
2. Press and hold down the SUMMER / WINTER key [key 10] for about 5 seconds.
The configuration
parameters, each of which
has its own preset value,
are identified on the display
by a number and writing. To
change the values of a
parameter use the keys
▲
[key 1] and
▼
[key 2]; to
move between the
parameters, use the key
►
[key 4].
To return to the initial page of the programming menu, press the ENTER key [key 5], which
saves the changes in the memory.
If no key is pressed for 3 minutes, the chronothermostat exits the configuration programme
and returns to the mode of operation previously in use, without saving.
To eliminate the changes made and restore the preset values of the configuration
parameters, press keys
▲
[key 1] and
▼
[key 2] simultaneously and hold them down for
about 4 seconds.
SCRITTA
VALORE
INDICE
