e n g l i s h
Put the hands at about 5 to 12 cm below the air output, the infrared sensor will start the dryer.
Remove the hands and the dryer will stop within about 5 seconds. The appliance power off automatically
over 1 minute of continuose funtioning.
CAUTION:
- Do not block both the inlet and the outlet of the air.
- Do not use to blow directly in the eyes.
- Ensure children do not play with the appliance.
- Do not spray water directly onto the appliance.
ATTENTION: before doing any work on the dryer unit, make sure the power is cut off.
Use a cloth dampened with water and a neutral detergent to clean the front cover.
Power cord replacement or any other part replacement, must be performed by a qualified person.
It’s important to check the wear of the motor brushes and to replace them when necessary.
To ensure efficient operation over a long period of time, keep the air intake and output free from dust and
objects. Failure to perform those operations will lead to the cancellation of the warranty.
3
FUNCTIONING with automatic sensor starting
4
MAINTENANCE AND CLEANING
This product conforms to EU Directive 2002/96/EC. The symbol of the barred waste bin indicates
that, at the end of its useful life, the product has to be collected separately from the domestic waste.
The user will have to take the product to a collection centre for waste electrical and electronic
equipment, or return it to a retailer on purchase of a replacement. Failure to do so may incur the
penalties established by laws governing waste disposal.
Proper differential collection and the subsequent recycling, processing and environmentally
compatible disposal of waste equipments avoids unnecessary damage to the environment and
possible related health risk and promotes also recycling of the materials used in the appliance.
FANTINI COSMI S.p.A.
Via Dell’Osio, 6 - 20090 Caleppio di Settala, Milano, Italy
Ph. +39 02 956821 | Fax +39 02 95307006 | [email protected]
www.aspira.it
5679947 07-2019
Figure 1
•
Hook the base of the product into the mounting bracket
•
Fix the product to the wall with screws in the lower holes (B)
•
Connect the plug
A
B
