17
OPERATION
(CONT'D)
OPTIONAL INTELLITEK CONTROL
Note:
All controls are low voltage. 18 to 24 gauge wire is recommended.
EDF2
INTELLITEK MULTI-
FUNCTION WALL
CONTROL
Control multiple functions of
your Fantech SER with one
slimline wall control. Two wire
connection simplifies installa-
tion. Use one 2M per SER
installed.
FILTER LIGHT RESET & MODE FAN
SPEED SELECTOR
Press to reset the filter mainte-
nance reminder light. The com-
bination filter light reset and up
setpoint selector buttons let’s
you choose at which speed the
HRV, ERV unit will operate at.
Pressing the filter light reset but-
ton once displays the mode fan
speed on the LCD. The LCD
should display one of the follow-
ing three letters, L for Low, M for
Medium and H for High. To
change the mode speed,
press the up setpoint
until desired speed is displayed,
selector. After 1 second of inac-
tivity, the LCD will return to rela-
tive humidity reading.
OVERRIDE TIMER
When pressed, unit will
provide high speed
ventilation for 15 minute
period. Once the time
elapsed the unit will return
to its normal function. To
move from one time to the
other, continue pressing the
timer button until you reach
the desired time.
DIGITAL HYGROMETER DISPLAY
Shows Indoor Humidity Level
This control will not read below
29% RH
DEHUMIDISTAT CONTROL
A Dehumidistat is ideal for use in energy efficient houses where
indoor humidity (during the heating season) is higher than outdoor
levels. High humidity is a major cause of structure damage and IAQ
problems such as mold and mildew. This feature can be turned off
when installed in climates that do not require it.
MAINTENANCE LIGHT
When the light is on it indicates
it may be time to clean unit. To
reset the light, after cleaning the
filters, just push the power but-
ton and restart the unit. This
will turn the light off and reset
the clock for your filter check.
POWER
On/Off
This function is to turn your
unit on or off. To go from
the on to off position just
press once.
MODES
Select Intermittent, or
Continuous Ventilation Modes.
Continuous
This function will exchange
outside air with your stale
air.
Intermittent
This function will put your
unit on stand by and can
be over ride by timer, air quality
sensor, etc
To move from function to the
other, continue pressing the
mode button until you reach the
desired function. This function
goes from Continuous to
Intermittent.
The LCD (Liquid Crystal Display) indicates the percentage of Relative
Humidity in the air surrounding the control and ultimately in the
house. Pressing either of the setpoint selectors ( , ) once, will
display the desired RH level. The setpoint selection mode is now acti-
vated and can be adjusted with either selectors to a newly desired set-
point. The LCD will return to the actual RH level display after a few
seconds.