1
Manual
NVMePCIe TR-1
Manufacturer Article No.: 2515
EAN: 4250273425154
1. Introduction
Thank you for purchasing the FANTEC NVMePCIe TR-1 PC card. The FANTEC PCIe card
allows you to use an NVMe PCIe SSD internally, removably in your PC. The NVMe is
mounted on a slide-in carrier and plugged into the card‘s removable frame at the back of
your PC via the slot bracket. This allows you to use and change the NVMe quickly,
conveniently, without tools in your PC - without opening the PC.
Before you start with the installation of the card in your PC and the installation of your
NVMe please read this manual carefully. For the installation you need a fine cross
screwdriver. You are handling very small screws. For this, use a secure surface on which
the screws cannot roll away if they slip out of your hands.
2. Assemble slide-in carrier
2 a.
Preparing the NVMe SSD
Place the NVMe into the connector on the slide-in tray. Gently push the NVMe into the
horizontal position and check that the black screw bolt of the slide-in tray is positioned
so that it is under the mounting notch at the end of the NVMe. Usually, the position is
prepared for a 2280 NVMe.
If you are using a shorter NVMe, remove the NVMe from the tray again and carefully
place the screw bolt in the correct position. It can be removed from the prepared position
by sliding it on the slotted hole, and then slide it back into the notch at the correct
position. The bolt is loosely inserted. It is not screwed. Be careful not to lose it.
