4
B.
To open the Nano Spotter, hold the hand grip firmly in one
hand and turn the flashlight head counterclockwise until it
separates. Pull the flashlight head off. Please make sure
that the light is pointed in an upward position so contents
do not fall out when opened. Take special care not to stare
into the light beam which is very powerful and could
damage your eyes.
C.
Gently remove the LED head (the white component with 5
LED bulbs) by pulling it out.
D.
Install or remove the 4 AAA Alkaline batteries carefully.
Please note that this light should not be used with
rechargeable batteries. Make sure that you follow the
instructions diagram printed on the inside of the light. Note
that there are two sets of two batteries, each set pointing
in a different direction.
E.
Replace the LED head carefully, making sure that the two
protrusions on the inside of the battery compartment
correspond with the two niches on the LED head. This is
the only way it will fit properly.
F.
Carefully place the flashlight head over the threads, and
tighten evenly in a clockwise fashion. Do not use force and
do not allow it to screw down unevenly. Take special care
not to stare into the light beam which is very powerful and
could damage your eyes.
G.
It is recommended to occasionally apply a slight amount of
silicone grease to the black O-ring seal found on the
flashlight after unscrewing the flashlight head
counterclockwise.
H.
In order to attach the cone to the flashlight again, simply
cover the flashlight’s head with the open side of the cone,
so it wraps around it. The cone is held by friction on the
flashlight’s head. There is no need to force the cone down
Summary of Contents for Nano Spotter
Page 1: ...1 ...
