FRX100 III Housing Instruction Manual 20141005
17
4.
If inserting a silica gel pack inside the housing in order to prevent moisture, it is best to insert it
on the left side of the camera, in the slot midway up between the two rubber shock absorber
mounts, where it doesn’t interfere with proper housing operation. It is important to make sure
that the silica gel pack doesn’t stick out, or else it might interfere with the watertight seal of the
housing.
CLOSING THE HOUSING
1.
Turn the housing Control
Dial till the
Intelligent Auto
shooting mode symbol is
positioned at the left (image
#11). Make sure not to
accidently turn this control
any further before closing
the housing.
2.
Turn the latch dial so that
the small red tab located on
the latch is pointed towards the front side of the housing (image #12).
3.
Carefully close the back door of the housing, pushing it against the front door, while making sure
there is nothing sticking out of the housing or impairing the smooth closure of the back door.
Then firmly press the back door against the forward section of the housing.
4.
Turn the secure dial clockwise till the lock dial clicks. The small red tab should then be pointed
towards the bottom of the housing (image #13).
Image #11
Image #12
Image #13
