11
CONTROL PANEL OPERATION
INITIAL START-UP -
When the spa is first powered up it will go into priming mode, indicated
by
Pr
. The priming mode will last for
less than 5 minutes and then the spa
will begin to heat and maintain the
water temperature when in Standard
Mode. Your spa has been designed so
that it will automatically heat the water
to the factory set temperature of 100
°
F
unless you set the spa to a different
temperature. If power is disconnected from the spa, it will automatically revert back to the factory
set temperature of 100
°
F when power is reapplied.
TEMPERATURE ADJUSTMENT (80°F-104°F)
The temperature can function between 80°F - 104°F / 26°C - 40°C. The last measured
temperature will constantly display on LCD.
Press the
Up
or
Down
buttons to display the set temperature. Each time either button is pressed
again, the set temperature will increase or decrease depending on which button is pressed. After
three seconds, the LCD will automatically display the current spa temperature.
JETS OPERATION
Firmly press the
Jets
button once to activate the low speed of the pump and again for the high
speed. Firmly press the
Jets
button again to turn off the pump. If left running the low speed of the
pump will automatically turn off after 4 hours. The high speed pump will automatically turn off after
15 minutes. The low speed of the pump may also activate for at least 2 minutes every 30 minutes
to detect the spa temperature and then to heat to the set temperature if needed, depending
upon mode. When the low speed turns on automatically it cannot be deactivated from the panel:
However the high speed may be started.
MULTI COLOR LED LIGHT
Press the
Light
button once to turn on the light. Press the button again to turn the light off. Every
time the light is quickly turned off and back on, a new color will illuminate. There are 6 different
colors followed by a color wheel. The color wheel starts out as a white light. Exiting the color
wheel may require you to press the
light
button quickly 4 times or more.
NOTE:
The blue color is the first of the 6 colors followed by the color wheel. If left on, the light will
automatically turn off after 4 hours of operation.
OPERATIONAL MODE
The Standard Mode is the default operational mode preset from the factory. In order to program
the spa to operate in the other 2 modes allowing you to change the mode, dip switch #7 on the
control box board must be moved downward into the "off" position (See page 9).
If your spa has been modified to allow mode change, press the
Up
or
Down
button, then while the
display is flashing press the
light
button to go into Standard, Economy or Sleep Mode.
Summary of Contents for MUSE
Page 1: ...OWNER S MANUAL PLUG PLAY EMBRACE MUSE ELUSION...
Page 26: ...NOTES...
Page 27: ......
Page 28: ...PART 303343 REV B 4 12...