Fanmaster IDH2-50IN, Instruction Manual

Page: 6 / 16

3. ASSEMBLING INSTRUCTIONS - CONTINUED
1. Insert the wheel shaft “K” to the corresponding holes of the feet pipe
assembly “B”.
2. Insert the cotter pin “J” to the corresponding holes; slide the wheel “I”
over the wheel shaft “K”, put plain washer “H” to the two sides of shaft,
screw the nut “G” to fix the wheel on the shaft.
3. Put the heater body on the feet pipe assembly “B”, make sure the 4 holes
of handle “A” point towards the corresponding 4 holes on the feet pipe
assembley “B” respectively.
4. Using the screw “F”, spring washer “E”, plain washer “D” and nut “C” to fix
the feet pipe assembly and handle to the tank.