How to Assemble Your Ceiling Fan Blades and Cap
INSTALLATION NOTE
Do not connect fan blades until the fan is completely
installed. Installing the fan with blades assembled may
result in damage to the fan blades.
ʆ
WARNING
To reduce the risk of personal injury, do not bend the
blades when installing, balancing or cleaning the fan.
Do not insert foreign objects in between the rotating
blades.
NOTE: You will find the fan blade set packed in its own
carton and hardware bag in the fan box.
Blade
Blade
Figure 2
Figure 3
Figure 1a
Figure 1b
Þ6HDG6FUHZ
ZLWK6WDLQOHVV)ODW:DVKHU
SHUDERYHWKHEODGH
Þ6HDG6FUHZ
ZLWK6WDLQOHVV)ODW:DVKHU
SHUEHORZWKHEODGH
x 18
x 18
STAINLESS
FLAT WASHER
HARDWARE USED:
3/16
ß
-24
SERRATED HEAD
SCREWS
0RWRU
0RWRU
NOTE: You will find plastic cap in fan blade set carton.
12
4.
Attach the plastic cap assembly to the motor
assembly, which is held in place by a magnet.
(Figure 4)
Figure 4
3ODVWLF&DS
0RWRU
$VVHPEO\
WARNING
To avoid injury to your hand, please be careful when
installing the plastic plate to the magnet on the motor
assembly as the strength of the magnet will quickly
attract the cap, causing it to snap down, possibly
pinching or crushing your hand.
2.
Position blade along the motor, aligning blade
1A. MAD8530**
Remove and discard the three rubber/screws
motor stops from the motor assembly. (Figure 1a)
1B. MAD8531**
Remove and discard the six rubber/screws
motor stops from the motor assembly. (Figure 1b)
holes with holes in the top of the motor assembly
flywheel. Make sure the blade is fully seated against
the flywheel and install serrated head screwswith
stainless flat washers from the hardware bag, but
don't fully tighten at this time. (Figure 2)
3.
Install and securely tighten all screws with stain-
less flat washers at the underside of the blades , then
securely tighten all previously installed screws on top
of motor. (Figure 3)
0RWRU
6WRSV
0RWRU
6WRSV
