12
1.
Remove and discard the (rubber) motor “stops” by
removing the five screws. (Figure 1)
2.
Lay the side of the blade holder on a flat surface
with the inside of the blade holder facing up.
3.
Assemble the blade to the blade holder with the
carriage nuts, washer-head screws and the blade
cover. Make sure the bottom edge of the blade is fully
seated against the blade holder.
4.
Tighten screws with a screwdriver, don’t overtighten.
(Figure 2)
Blade & Blade Holder Assembly:
How to Assemble Your Ceiling Fan Blades and Switch Housing
Figure 1
Do not connect fan blades until the fan is completely
installed. Installing the fan with blades assembled
may result in damage to the fan blades.
To reduce the risk of personal injury, do not bend the
blade holders when installing, balancing the blades or
cleaning the fan. Do not insert foreign objects in
between the rotating blades.
WARNING
INSTALLATION NOTE
5.
Attach assembled blades and blade holders to the
motor hub using the provided screws. (Figure 3)
6.
Make sure the screws securing the blade holders to
the motor hub are tight and that the blade holders are
properly seated.
Fan
Blade
Blade
Holder
Blade Holder
Cover
Figure 4
7.
Disassemble the housing switch cup/adapter
assembly by removing three screws. (Figure 4)
Housing Switch Cup/Adapter Assembly:
1/4"-20
Screw
X 10
HARDWARE USED:
1/4"-20 Screw
(2 per blade
holder)
X 10
X 10
HARDWARE USED:
3/16"-24
Carriage Head Nuts
3/16"-24
Washer Head Screws
Figure 2
Figure 3
