Fanimation Vetricco FP3120 Series, Owner'S Manual

Page: 5 / 16

5
How to Assemble Your Ceiling Fan (cont’d)
NOTE: You will be using either the 6 ˝ downrod supplied with
your fan or an optional downrod purchased seperately.
4. Loosen the two setscrews in the Downrod Support. Align
the Clevis Pin holes in the Downrod with the holes in the
Downrod Support. Install the Clevis Pin and secure with
the Hairpin Clip. (Figure 3) Be sure to push the straight
leg of the hairpin clip through the hole near the end of the
clevis pin until the curved portion of the hairpin clip snaps
around the clevis pin. The hairpin clip must be properly
installed to prevent the clevis pin from working loose. Pull
on the Downrod to make sure the clevis pin is properly
installed.
5. Route wires and support cable through Motor Coupling
Cover and through opening in Canopy. Position Canopy
on fan shown with open side facing up. (Figure 2)
6. Reinstall the Hanger Ball (Figure 3) on the Downrod as
follows. Route the four 80 ˝ wires through the Hanger Ball.
Position the Pin through the two holes in the Downrod
and align the Hanger Ball so the Pin is captured in the
groove in the top of the Hanger Ball. Pull the Hanger Ball
up tight against the pin.
Securely tighten the setscrew
in the Hanger Ball. A loose setscrew could create fan
wobble.
7. While pulling up on the hanger ball, securely tighten the
two 3/16-24 x 13mm setscrews in the downrod support.
(Figure 3)
NOTE: The setscrews must be properly installed as
described above, or fan-wobble could result.
8. Slide the Motor Coupling Cover down until it touches the
top of the Housing. (Figure 4)
5. Install three Candelabra Bulbs (not included - 40
watts max) in each of the sockets on the Upper Housing
Assembly. (Figure 4)
10. The fan comes with orange, blue, black, and white
leads. Before installing fan, measure up approximately 6-9
inches above top of Downrod/Hanger Ball Assembly. Cut
off excess wire and strip back insulation ½
˝ from end of
wire.
11. You have now completed the upper assembly of your
new ceiling fan. You can now proceed with the hanging
and the electrical wiring of your fan.
Downrod
Support
Ceiling
Canopy
Downrod/Hanger
Ball Assembly
Upper
Housing
Setscrew (2)
Figure 2
Ceiling
Canopy
Setscrew
Downrod
Pin
Figure 3
Figure 4
Hairpin Clip
Clevis Pin
Motor
Coupling
Cover
Reversing
Switch
▲ WARNING
It is critical that the clevis pin in the downrod support
is properly installed and the setscrews are securely
tightened. Failure to verify that the pin and setscrews
are properly installed could result in the fan falling.
Motor
Coupling
Cover