12
How to Operate Your Ceiling Fan (cont’d)
Figure 23
4.
The remote buttons instruct as below:
I = minimum speed II = low speed
III = medium low speed IV = medium speed
V = medium high speed VI = high speed
Button:
This button turns the fan off.
Reverse button:
This button is to control fan direction.
The button is to control light, Infinite light levels
are available by holding the light on/off button
(Figure 23).
Light button:
Fan speed:
Code Switches
Figure 24
How to Replace Receiver
1.
Remove motor coupling cover by unscrewing
the two screws. (Figure 25)
2.
3.
Tight the two screws from the motor coupling cover.
(Figrue 27)
Figure 25
Motor
Coupling
Cover
Figure 27
4.
After installing new receiver to your fan, operate the
remote “Code Setting” process on “How to operate your
ceiling fan” Step 3 again.
Unplug antenna, signal wire and 9-PIN connector then
replace new receiver. (Figure 26)
Figure 26
Receiver
9-Pin
Connector
Signal Wire
Antenna
5.
“D” and “ON” dip switch:
The “ON” selection is the light dimmable selection and is
to be used with all bulbs other than CFL. The “D”
selection is the light on only (no dimming function) and
is to be used with CFL bulbs (as CFL bulbs cannot be
dimmed). The receiver provides the following protective
function: (Figure 24)
Lock position: The DC motor has a built-in safety feature
against blade obstruction against obstruction during
operation. If something obstructs the fan blades the
motor will stop operating after 30 seconds of
interruption. Please remove obstacles and reset.
Over 80W protection: When the receiver detects motor
power consumption which is greater than 80W, the
receiver power will shut down and fan operation will
cease. Disconnect the power supply and after 5
seconds return power on to the fan.
