5
How to Assemble Your Ceiling Fan
1.
Remove the Hanger Ball by loosening the setscrew in the
Hanger Ball until the ball falls freely down the Downrod. (Figure
1) Remove the Pin from the Downrod, then remove the Hanger
Ball. Retain the Pin and Hanger Ball for reinstallation in Step 4
(Figure 4).
2.
The fan comes with blue, black, and white 80
˝
wires. Separate
and untwist the three wires. Route the wires through the
Downrod.
NOTE:
You will be using either the 6
˝
or the optional longer
downrod/square sleeve purchased separately.
3.
Loosen the two setscrews in the Downrod Support. Align the
Clevis Pin holes in the Downrod with the holes in the Downrod
Support. Install the Clevis Pin and secure with the Hairpin Clip.
(Figure 2) Be sure to push the straight leg of the hairpin clip
through the hole near the end of the clevis pin until the curved
portion of the hairpin clip snaps around the clevis pin. The
hairpin clip must be properly installed to prevent the clevis pin
from working loose. Pull on the Downrod to make sure the clevis
pin is properly installed.
4.
Route wires through Square Motor Coupling Cover, Square
Sleeve, Canopy Screw Cover and through opening in Canopy.
Position Canopy Screw Cover and Canopy on fan shown with
open side facing up. (Figures 3 & 4)
5.
Reinstall the Hanger Ball (Figure 4) on the Downrod as follows.
Route the three 80
˝
wires through the Hanger Ball. Position the
Pin through the two holes in the Downrod and align the Hanger
Ball so the Pin is captured in the groove in the top of the Hanger
Ball. Pull the Hanger Ball up tight against the pin.
Securely
tighten the setscrew in the Hanger Ball. A loose setscrew
could create fan wobble.
Figure 2
Figure 3
Pin
Setscrew
Hanger
Ball
Figure 4
Figure 1
6.
While pulling up on the hanger ball, securely tighten the two
setscrews with nuts in the downrod support.
(Figure 2)
NOTE:
The setscrews must be properly installed as described
above, or fan-wobble could result.
7.
Slide the Square Motor Coupling Cover and Square Sleeve
down as shown. (Figure 3)
8.
Before installing fan, measure up approximately 6-9 inches
above top of Downrod/Hanger Ball Assembly. Cut off excess
wire and strip back insulation ½
˝
from end of wire.
9.
You have now completed the upper assembly of your ceiling
fan. You can now proceed with the hanging and the electrical
wiring of your fan.
▲
WARNING
It is critical that the clevis pin in the downrod support
is properly installed and the setscrews are securely
tightened. Failure to verify that the pin and setscrews
are properly installed could result in the fan falling.
Square
Canopy
Square
Downrod
Sleeve
Downrod
Support
Square
Motor
Coupling
Cover
Canopy
Screw
Cover
Clevis Pin
Reverse
Switch
Reverse
Switch
Hairpin Clip
Screw with
Locknut (2)
