7
How to Wire Your Ceiling Fan
If you feel that you do not have enough electrical wiring knowledge or experience, have your fan installed by a
licensed electrician.
To avoid possible electrical shock, be sure electricity
is turned off at the main fuse box before hanging
(Figure 10).
WARNING
NOTE:
If you are not sure if the outlet box is
grounded, contact a licensed electrician for advice, as
it must be grounded for safe operation.
NOTE:
The hand-held remote included with this fan
has 16 different code combinations. To prevent
possible interference from or to other remote units,
simply change the combination code in your
transmitter and receiver.
1.
To set the transmitter code, remove battery cover
by pressing firmly below arrow and sliding cover
off. Slide code switches to your choice of up or
down position. Factory setting is all up. Do not use
this position. With a small screwdriver or ball point
pen slide firmly up or down. Replace battery cover
on the transmitter (Figure 11).
2.
To set the receiver unit code, slide code switches
to the same positions as set on your transmitter
(Figure 12).
3.
Slide the receiver unit into the open end of the
hanger bracket (Figure 13).
RECEIVER
UNIT
DETAIL
CODE SWITCHES
Figure 12
12V/23A BATTERY
REMOTE
CONTROL
DETAIL
TRANSMITTER CODES
Figure 11
MAIN FUSE BOX
Figure 10
HANGER BRACKET
RECEIVER UNIT
Figure 13
N
L1
L
Terminal Block
on Bracket
Fan
Wiring
Receiver
Unit
220VAC
Household
Supply
LIVE-Red/Brown
Orange
NEUTRAL-
Blue/Black
EARTH – Green/Yellow
Brown to Motor
Blue
Orange to Light
Green/Yellow
BLK-ANT
BLUE-
AC IN N
BRN-
AC IN L
BLUE-To Motor N
BRN-To Motor L
GRN/YEL
from hg
r. ball
GRN/YEL
from bracket
ORG-For Light
Figure 14
4.
Connect wires to terminal block as indicated:
Green hanger bracket and banger ball wires to
green/yellow (earth) wire. Brown receiver unit wire
(AC IN L) to red/brown live supply wire. Blue
receiver unit wire (AC IN N) to blue/black neutral
supply wire. Orange receiver unit wire (AC IN L1)
to orange for light.
Position all connected wires and receiver antenna
to allow installation of ceiling canopy. Using
canopy screws threaded into the hanger bracket
reinstal ceiling canopy. Restore electrical power
(Figure 14)