1.
Check to see that you have received the following parts:
NOTE:
If you are uncertain of part description, refer to
exploded view illustration.
This Manual Is Designed to Make it as Easy as Possible for You to Assemble,
Install, Operate and Maintain Your Ceiling Fan
Tools Needed for Assembly
•
One Phillips head screwdriver
•
One stepladder
•
Three wire connectors (supplied)
3
Installed Wire Length
Wire Size A.W.G.
Unpacking Instructions
For your convenience, check-off boxes are provided next to each step. As each step is completed, place a check
mark in the box. This will insure that all steps have been completed and will be helpful in finding your place should
you be interrupted.
Before assembling your ceiling fan, refer to section
on proper method of wiring your fan (page 4). If you
feel you do not have enough wiring knowledge or
experience, have your fan installed by a licensed
electrician.
Do not install or use fan if any part is damaged or
missing. This product is designed to use only those
parts supplied with this product and/or any
accessories designated specifically for use with this
product by Fanimation. Substitution of parts or
accessories not designated for use with this product
by Fanimation could result in personal injury or
property damage.
WARNING
!
WARNING
!
•
One wire stripper
Up to 50 ft.
14
50-100 ft.
12
•
One 1/4” blade
screwdriver
Materials
Wiring outlet box and box connectors must be of type
required by the local code. The minimum wire would be a
3-conductor (2-wire with ground) of the following size:
NOTE:
Place the parts from the loose parts bags in a small
container to keep them from being lost. If any parts are
missing contact your local retailer.
• Fan Motor Assembly
• Hanger Bracket Assembly with
screws
• Downrod/Hanger Ball Assembly
• Ceiling Canopy
• Canopy Screw Cover Assembly
• Motor Coupling Cover Assembly
• Blade Arm Set
• Blade Set
• Light Plate Lower Assembly
• Two E27 15W Bulbs
• Glass Assembly
• Hardware bags:
– 3/16-24 x 8mm
(blade to blade holder)
Washer Head Screw
–
3/16” Fiber Washer
(blade to blade holder)
– 1/4”-20 x 14mm
(blade arm to motor)
Pan Head Screw
– Phillips Screwdriver, 4“
–
Four Wire Connectors
–
Balance Kit
HARDWARE BAG
DOWNROD/
HANGER BALL
ASSEMBLY
BLADE SET
MOTOR
COUPLING
COVER
CANOPY
SCREW
COVER
ASSEMBLY
CEILING
CANOPY
BLADE ARM SET
TWO E27
15-WATT BULBS
HANGER
BRACKET
ASSEMBLY
W/SCREWS
FAN MOTOR
ASSEMBLY
GLASS
Assembly
LIGHT PLATE
LOWER
ASSEMBLY
• TR4WH-220V Remote Control
• Receiver Unit
RECEIVER
UNIT
TR4WH-220
REMOTE
CONTROL