5
How to Assemble Your Ceiling Fan (cont’d)
6.
Route wires through opening in Motor Coupling Cover.
Position Motor Coupling Cover on fan shown with open
side facing down. (Figure 2)
7.
Route wires through opening in Canopy. Position
Canopy on fan shown with open side facing up. (Figure 3)
8.
Reinstall the Hanger Ball (Figure 3) on the Downrod
as follows. Route the three 80
˝
wires through the Hanger
Ball. Position the Pin through the two holes in the Downrod
and align the Hanger Ball so the Pin is captured in the
groove in the top of the Hanger Ball. Pull the Hanger Ball
up tight against the pin.
Securely tighten the setscrew
in the Hanger Ball. A loose setscrew could create fan
wobble.
9.
While pulling up on the hanger ball, securely tighten
the two 3/16-24 x 3/8
˝
setscrews in the downrod support.
(Figure 2)
NOTE:
The setscrews must be properly installed as
described above, or fan-wobble could result.
10.
Slide the Motor Coupling Cover down until it touches
the top of the Housing. (Figure 3)
11.
The fan comes with blue, black, gray and white leads.
Before installing fan, measure up approximately 6-9 inches
above top of Downrod/Hanger Ball Assembly. Cut off
excess wire and strip back insulation ½
˝
from end of wire.
12.
You have now completed the assembly of your new
ceiling fan. You can now proceed with the hanging and the
electrical wiring of your fan.
Ceiling
Canopy
Downrod/Hanger
Ball Assembly
▲
WARNING
It is critical that the clevis pin in the downrod support
is properly installed and the setscrews are securely
tightened. Failure to verify that the pin and setscrews
are properly installed could result in the fan falling.
Figure 3
Motor
Coupling
Cover
