Fanelite PRICKLY 38YFT-7057M, Operating Manual, Page: 20 / 26

20
1/ Remove the screws and washers on the motor used to attach the blades. Position each
blade on the motor (one way only, with the "Side up" label up) and replace the screws and
washers. Caution, tighten the screws carefully to avoid damaging the blades, but be sure to
tighten properly to prevent excessive vibration during start-up. Then remove the 4 screws
from the LED light/speaker kit and loosen the connections.
2/ Take the bottom cover of the ceiling fan and position it correctly on the motor by inserting
the 3 screws in the notches. Turn clockwise until it locks in place and tighten the 3 screws.
Take the LED light/speaker kit and connect the connectors with those of the ceiling fan.
Position it correctly and replace the 4 screws.
3/ Put the two cups on the down rod correctly, remove the bolt-pin kit from the motor and the
screws, pass the wires inside the down rod and position the down rod correctly on the motor
(only 1 possible direction, hanger ball to the ceiling). Replace the bolt-pin kit, by taking care
to not damage the wires running inside, then tighten strongly. Retighten the screws on the
down rod so that it is firm.
9. HANGING THE CEILING FAN
Put the hanger ball into hanger bracket, turn the down rod, let the concave groove of hanger
ball into the lugs of hanger ball plate (in hanger bracket).
Be careful to not damage the electrical wires and not wedge them between the hanger
ball and hanger bracket. Make sure that the ceiling faN is securely locked. Concave
groove of hanger ball must be putted into the bracket lugs.
10. ELECTRICAL CONNECTIONS
WARNING : Before proceeding to the electrical connections, carefully read the safety
instructions in this manual. Before any electrical connections, switch off all power and
restart only when the installation is complete.