Fanelite PRICKLY 38YFT-7057M, Operating Manual

Page: 21 / 26

21
On this model, the receiver of the remote control is already installed into the motor cover.
Make the following electrical connections :
1/ Connections from ceiling fan to hanger bracket
- Connect the connector of the hanger bracket (3 wires : brown or black/blue/yellow and
green) to that of the ceiling fan.
2/ Connections from hanger bracket to AC power
By using the connecting terminals provided on the hanger bracket :
- Connect the phase of the ceiling with the phase of the hanger bracket in the connecting
terminal L.
- Connect the neutral of the ceiling with the neutral of the hanger bracket in the connecting
terminal N.
3/ Grounding
- Connect the ground wire of the ceiling to that of the hanger bracket in the connecting
terminal E.
- Connect one of the two grounding connectors of the hanger bracket to that of the hanger
ball of down rod.
- Connect the other grounding connector of the hanger bracket to that of the ceiling fan.
Check that all electrical connections have been correctly made and that the wires are
properly stored in the hanger bracket. Fit the canopy to the hanger bracket, place it correctly
and fix it with the screws.
11. USING THE REMOTE CONTROL
Insert the supplied battery into your remote control.
Operation
Press the BLUETOOTH button to activate or deactivate the Bluetooth
mode.
Press the + button to turn on the ceiling fan and increase the speed (6
speeds).
Press the - button to decrease the speed. Hold for more than 2 seconds to
turn off the ceiling fan.
Press the LIGHT button to turn the light on or off.
Press the TIMER button to set the timer (automatic stop once the selected time has been
reached), the corresponding LED will illuminate : 1 LED = 1 hour / 2 LED = 2 hours / 3 LED =
4 hours / 4 LED = 8 hours
Synchronizing the remote control and the receiver
By default, the remote control and the receiver are already synchronized together. If the
receiver is not connected to the remote control, please follow the steps below :