-3-
A
Photography lights will be installed in the camera or
photographic camera lights before removed, is required to set
the power switch in OFF.
Parts diagram
Photography lights installed
Photographic lights removed
The use for photographic light
1. The opposite direction along the arrow anti-clockwise rotating locking to Release it
2. The opposite direction along pull out the photographic light, removed it
Note
B
1. Optical lens
2. Single/Double light switch
3. Battery lock
4. Mains switch on/off
5. Hot shoes fastening intortum
2
3
4
5
1
1. Rotating photographic lights, make it with the consistent direction of the camera lens
2. Photography lights interface will be inserted into the interface of the camera
concave-shaped
3. Clockwise rotating locking until locked in place
1. To following the picture to install the battery, when heard a weak "pyridaben
carbazole" sound the installation is completed.
2. When need to replace the battery push the battery lock "BATT" in accordance with
the arrow direction to promote the battery can be unloaded.
3. When you turn on the photographic light please set the power switch to "POWER"
4. When you turn off the photographic light please set the photographic light to "OFF
5. When open a single light switch to single-and double-set light to the L1;When
open a double light switch to single-and double-set light to the L2.
1. When the electric will run out of time, power will be cut off, after few seconds it
will re-open, it can still light up a few seconds,then will be cut off again. Please
replace the batteries at this time, to prevent influence on use.
2. After use Please set the power switch to "OFF"
3. When not in use, please remove the battery and then bring photographic lights
stored in boxes.
4.
In storage before, make sure photography lights are cool.
