Start-up of the device/introduction
• Select a suitable location for the device, such as a dry, flat, non-slip surface on which it is easy to operate the
machine.
• Ensure that the device is sufficiently ventilated.
• Remove the protective film from the display if it is still present.
Power Supply
• Ensure that the voltage is the same as that indicated on the model identification plate.
• Connect the power cable supplied (see battery compartment if necessary) to a properly installed safety power socket
and the mains connector AC on the back of the machine.
Inserting the Batteries
(not supplied)
1. Open the lid of the battery compartment.
2. Insert 6 batteries of type UM-2 (“C” size) 1.5 V. Please ensure that the polarity is correct (see the floor of the battery
compartment)!
3. Then close the battery lid.
NOTE:
When a mains cable is connected the batteries are automatically switched off.
CAUTION:
• Batteries can leak and lose battery acid. When not using the system for a long period of time, remove the batteries.
• Different battery types or new and used batteries must not be used together.
• Do not dispose of batteries with household waste. Return old batteries to the respective collection facilities or your
dealer.
WARNING:
The batteries shall not be exposed to excessive heat such as sunshine, fire or the like. Danger of explosion!
Setting the clock
The system must be in standby mode in order to set the clock.
1. Press and hold the “PLAY / PAUSE / CLOCK” button for approx.2 seconds.
2. Use the “SKIP+ / ” & “SKIP- / TUNING-” buttons to set the time format “12 / 24hr”.
3. Press the “PLAY / PAUSE / CLOCK” button to confirm time format.
4. Use the “SKIP+ / ” & “SKIP- / TUNING-” buttons to set the hours accordingly. The hour digits start
flashing.
5. Press “PLAY / PAUSE / CLOCK” button to confirm the hour.
6. The minute digits start flashing. Use the “SKIP+ / ” & “SKIP- / TUNING-” buttons to set the minute
accordingly.
7. Use the “SKIP+ / ” & “SKIP- / TUNING-” buttons to set the minute accordingly.
8. Press “PLAY / PAUSE / CLOCK” button to confirm the minute.
NOTE:
• The clock time settings will be erased in the event of power interruptions.
• Press and hold the “PLAY / PAUSE / CLOCK” button during operation order to briefly display the current time.