
- 4 -
Refer to the user manual of the receiver for a detailed description of pairing
and unpairing of the buttons with the receiver.
The following is an example of how to handle receivers:
FW-R1, FW-R2, FW-STR1, FW-LED2, FW-D1.
Pairing
Once the receiver is correctly connected, press and hold
the PROG button until the device switches on the output
circuit and the communication LED goes out.
Tap the desired touch field.
②
①
③
A proper pairing will be confirmed by switching off the output circuit tem-
porarily and turning the LED on again.
Exiting the programming mode of the receiver is automatic after 30 se-
conds of waiting for the signal from the transmitter or after short pressing
the PROG button.
Unpairing
Unpairing the flush-mounted transmitter from the receiver is only possible by clearing the list of
all transmitters in the receiver. To clear the list of transmitters connected to the receiver, press
the PROG button and keep it pressed for a minimum of 10 seconds. Rapid blinking of the com-
munication diode will indicate that the controller memory has been cleared.
Summary of Contents for FW-WSO2
Page 8: ......