F&F DR-30M, Manual

Page: 8 / 15

- 8 -
1. Disconnect the power supply.
2. Remove the external (back) sensor cover.
3. Connect the wires according to the wiring diagram.
4. Fasten the base to the floor with two screws.
5. Assemble the sensor housing - push on the outer cover.
6. Set the desired parameters.
7. Switch on the sensor power supply.
If the motion sensor is installed too close to the switched
light source, the system may be activated, which means
that the sensor will automatically switch on and off the
light source. It is necessary to move the sensor to an ap-
propriate distance away from the light source.
Mounting