Section 3: Drum Assembly
Take 1 white nylon washer
and 1 bearing. These are for
the axles on the drum side
pieces. Place washer first
then the bearing with the lip
side next to the washer.
Repeat for other side of
Tumbler.
Right (3-1b) and Left (3-1d)
axles do look different.
Place each drum side piece
in the holes located at the
top center of each frame.
Push each side piece toward
frame until bearings are in
frame hole. Repeat for other
side.
(photo 3-2)
Now it is time to assemble
the drum panels. Find the
panel labeled L1 and R1.
With the large screws,
fasten the piece to the drum
end pieces. This is where
two people really comes in
handy! The drum end pieces
are labeled to match the
mesh pieces so be sure L1
on the panel is matched up
with L1 on the drum and so
forth. Continue adding the
panels in order around the
drum (photo 3-3 & 3-4)
