Fancom LM.60i, Manual

Page: 18 / 39

LM.60i 7. Display
A5911664 - GB 100503 14
7. Display
The display indicates a possible status of the program (depending on the
position of the manual operation on the LM.60i).
After the LM.60i has been switched on, 3 characters will be displayed in
succession. These characters are the version number of the software (1
character per second).
7.1.1. In manual mode (at adjustment):
Display
indication Meaning
1. Adjusting CLOSE (minimum air inlet position).
2. Adjusting OPEN (maximum air inlet position).
3. Adjusting pre-defined air inlet position
F. Adjusting: Too small difference on the control input between
Close and Open adjustment.
E Error when determining a position within the control procedure.
(Error)
C. Controlling maximum air inlet position successful. (Close)
O. Controlling minimum air inlet position successful. (Open)
P. Controlling pre-defined air inlet position successful.
Indication of the potentiometer value. Too high, correct or too
low
7.1.2. In Automatic mode:
Display
indication Meaning
0.
Standstill position, waiting for a change in the control value or
feedback.
1. Actuator controls closed
2. Actuator controls open
3. Wait position after switch on (with control via 0-10V)
4. Wait position after switch on (with control via IO-net; duration is
address dependent)
5. Minimum wait position after a control action