Fancom IVM-TOUCH, Manual, Page: 12 / 30

G
9
g
The triac and analog screens may differ from your screen, as the controller only shows parts that have
been installed.
Set the triac settings as follows:
1. Enter the Installer menu (see "Working with the IVM-Touch" page 13).
2. Scroll down to the Triac menu.
3. Tap . The adjustment screen is shown.
4. Turn the rotary knob of the IVM-Touch to:

1%: the minimum position (the fan is barely running).

99%: the maximum position (the fan is only just running at high speed or 95% of the mains voltage).
5. Tap to confirm and wait until the screen below is shown.
6. Repeat the steps above to set the 99% triac settings.
7. If needed, repeat the steps above to set the 1% and 99% settings for the seconds triac control (IVM-Touch
2T10).
8. Set the rotary knob of the IVM-Touch to A (Automatic).
If the triac setting is not approved the alarm screen is shown. Check if the settings are correct.