31
7.3.6 DRI (Drift mode)
DRI range: -05 ... -01 OFF 001 … 005
DRI default: -05
The drift mode reduces overall resistance of the wheel and lets you turn the
wheel more easily. It almost works like power steering. It reduces the basic
dampening of the wheel in the range of -05 to -01 and makes the wheel turn
faster in the range of 001 to 005. If the value is set to values beyond -05 (or if the
games FFB interferes with this feature) you might experience some oscillation.
If that happens - reduce the value or turn DRI “-05”.
To change the active value, move the directional stick of the Fanatec® steering
wheel in the up or down direction. “-05” to “-01” is a damper effect (natural
damper), “OFF” is without damper effect and “001” or higher values are with
motor assistance to accelerate the steering wheel.
7.3.7 FOR (force), SPR (spring), DPR (damper)
FOR range: OFF 010 … 120
FOR default: 100 (%)
SPR range: OFF 010 … 120
SPR default: 100 (%)
DPR range: OFF 010 … 120
DPR default: 100 (%)
These force feedback modifiers give you the ability to change the force feed-
back signals of a game (only applicable if game uses these effects). In theory
there are three types of signals which a game can send: Force (pushes the
wheel in a specific direction), spring (pulls the wheel towards the dynamic cen
-
tre) and damper (creates friction). Not every game uses all types of effects and
some games even use only one type to create all different feelings. Using your
Tuning Menu in the CSL Elite Racing Wheel you can increase or reduce these
different effects individually. To change the active value, move the directional
stick of the Fanatec
®
steering wheel up or down.
Note:
If SPR is set to low values or ‘OFF’ the CSL Elite Racing Wheel will not
be able to move the attached steering wheel to the correct center position after
calibration run.
IMPORTANT:
Only set these values higher than 100% if the force feed-
back effects are clearly not strong enough and weaker in comparison to
other games. When the game sends full effects and the wheel is set to
100% then the device will work on its power limit. Pushing up one value
to a very high number or even raising multiple values will result in higher
load on the motor and increased heat generation.
For further information check the FAQ section on our website
