28
IMPORTANT:
Software measures protect the product from installation
of wrong firmwares on the device! Do not try to force installation of any
wrong firmware to the product to avoid damages.
IMPORTANT:
After a firmware update, the center position of the CSL
Elite Racing Wheel has to be manually calibrated again. This is also indi-
cated by the LED display of the steering wheel showing ‘CAL’. This warn-
ing will stop after manual calibration of the wheel center. See chapter
‘Hotkeys’
‘Wheel center calibration’ for more details.
IMPORTANT:
After a firmware update, the H-pattern shifters connect
-
ed to the CSL Elite Racing Wheel has to be manually calibrated again. See
chapter ‘Hotkeys’
‘Shifter calibration mode’ for more details.
7.2 Start-Up procedure
ATTENTION:
When initialization and auto calibration of the CSL Elite
Racing Wheel is in progress never touch the attached steering wheel in
order to avoid injuries or incorrect calibration!
•
Step1:
Press the ON/OFF button “
” at the front plate of
the CSL Elite Racing Wheel, marked in the picture to the
right:
•
Step2:
The fans start working, the LED above the ON/OFF
Button “ ” is lit red.
•
Step3:
The CSL Elite Racing Wheel starts turning to the right side
(clockwise) until mechanical limit is reached. Then it runs back to the the
left side (counter clockwise) and stops.
▪
at the center position (0°) if wheel center was manually calibrated
before.
Note:
If SPR is set to low values or ‘000’ the CSL Elite
Racing Wheel will stop in a different position after calibration run.
▪
at about -60° on the left hand side if wheel center was not yet
calibrated (e.g. after firmware update; see description above in
this chapter).
