FAN-TASTIC VENT, P.O. BOX 1627, ELKHART, IN 46515-1627
TEL. (800) 521-0298 www.fantasticvent.com
STEP 9.
REPLACE THE FUSE (from step 1) IN YOUR NEW
CONTROL PANEL AND ENJOY YOUR UPGRADED FAN-TASTIC
VENT. IF YOU NEED INSTALLATION HELP OR HAVE ANY OPERA-
TION QUESTIONS, CALL US MONDAY THROUGH FRIDAY 9:00 am -
5:00 pm TOLL FREE @ 800-521-0298
STEP 7 & 7b.
A “T” SHAPED KNOCKOUT FOR THE RAIN
SENSOR IS LOCATED INSIDE THE FAN BASE, 4”-5” FORWARD OF
THE PASSENGER REAR CORNER. USE A HAMMER AND SCREW-
DRIVER TO “KNOCK IT OUT”.
STEP 7c & 7d.
FEED THE RAIN SENSOR THROUGH THE “T”
SLOT, SECURING IT ON TOP OF THE BASE WITH THE #6 x 1/4”
PANHEAD PHILLIPS SCREW (SUPPLIED) AFTER HOOKING LEAD
SIDE ON PEG.
STEP 8.
TUCK LOOSE WIRES AS NEEDED.
SECURE THE
ENTIRE SCREEN ASSEMBLY AND LIFT MOTOR WITH 5 SCREWS
(BE SURE THE LIFT MOTOR SHAFT FITS OVER TOP OF THE
KNURLED END OF THE LIFT ARM).
Install New Control Panel
Close the Dome Lid
Replace the Fuse
10
Enjoy Your New Fan
Secure the Rain Sensor On Top
Feed the Rain Sensor Through
Clean the Knockout
Locate the “T” Shaped Knockout
9
11
8
7
7b
7d
5e
STEP 6 & 6b.
APPLY BUTT CONNECTORS TO CUT POWER SUPPLY LEADS 2”(approx.) FROM
STRAIN RELIEF KNOTS (6a). MODIFY LENGTH OF WIRES (as needed) ON THE NEW UPGRADE
ASSEMBLY, STRIP ENDS, INSERT TO APPLIED BUTT CONNECTORS AND CRIMP (6b).
*NOTE: IF
PREVIOUS POSITIVE POWER SUPPLY WAS DISCONNECTED FROM THE FUSE HOLDER VIA A
FEMALE CLIP, YOU DO NOT NEED TO INSTALL A BUTT CONNECTOR ON THE POSITIVE POWER LEAD
(use original connector and swap out with attached power lead on the new fuse holder).
POSITIVE POWER SUPPLY LEADS WILL BE BLACK OR RED 16 GAUGE WIRES.
6
STEP 7 IS FOR KITS WITH A RAIN SENSOR...
7c
6b
Hook Up Power
Apply Butt Connectors
STEP 5e.
CONNECT THE
WHITE LEAD w/BULLET CON-
NECTOR ON YOUR NEW UP-
GRADED SCREEN ASSEMBLY
TO THE DOME SWITCH IN THE
BASE.
PLUG IN SECURELY.
Connect to Dome Switch
*NOTE: Swap Power Leads
*
