FALMEC Milano Genova 120, Installation Manual

Page: 7 / 24

Before cleaning or carrying out maintenance operations, disconnect the
equipment by removing the plug or switching off the main switch.
Do not use detergents containing abrasive, acidic or corrosive substances
or abrasive cloths.
Regular maintenance guarantees proper operation and performance over time.
Special attention is to be paid to the metal anti-grease filters: frequent cleaning of the filters
and their supports ensures that no flammable grease is accumulated.
CLEANING OF EXTERNAL SURFACES
You are advised to clean the external surfaces of the hood at least once every 15 days to
prevent oily substances and grease from sticking to them. To clean the brushed stainless steel
hood, the Manufacturer recommends using "Magic Steel" wipes.
Alternatively
and for all the other types of surfaces , it can be cleaned using a damp cloth,
slightly moistened with mild, liquid detergent or denatured alcohol.
Finish off cleaning by rinsing well and drying with soft cloths.
Do not use too much water next to the push button control panel and
lighting devices in order to prevent humidity from reaching electronic
parts.
The glass panels can only be cleaned with specific, non-corrosive or non-abrasive detergents
using a soft cloth.
The Manufacturer declines all responsibility for failure to comply with these instructions.
CLEANING OF INTERNAL SURFACES
Do not clean electrical parts, or parts related to the motor inside the hood,
with liquids or solvents.
For the internal metal parts, see the previous paragraph.
LIGHTING
The range hood is equipped with high efficiency, low consumption LED spotlights with ex-
tremely long duration under normal use conditions.
Should the LED spotlight need to be replaced, proceed as shown in the figure.
12V
3
1
2
GREASE DRIP TRAY
It is advisable to clean the tray every 15 days.
Do not use corrosive, acid or alkaline detergents.
For more thorough cleaning, remove the oil collection tray (see figure) and wash it with hot wa-
ter and washing up liquid. Rinse it well and wait for it to be completely dry before reassembling
it. They are dishwasher safe.
3
2
1
The crossed-out trash or refuse bin symbol on the appliance means that
the
product is WEEE
, i.e.
“
Waste electrical and electronic equipment’’, accordingly
it
must not be disposed of with regular unsorted waste
(i.e. with ‘’mixed house-
hold waste’’), but it must be disposed of separately so that it can undergo specific
processing for its re-use, or a specific treatment, to remove and safely dispose of any sub-
stances that may be harmful to the environment and remove the raw materials that can be
recycled. Proper disposal of these products contributes to saving valuable resources and
avoid potential negative effects on personal health and the environment, which may be
caused by inappropriate disposal of waste.
You are kindly asked to contact your local authorities for further information regarding the des-
ignated waste collection points nearest to you. Penalties for improper disposal of such waste
can be applied in compliance with national regulations.
INFORMATION ON DISPOSAL IN EUROPEAN UNION COUNTRIES
The EU WEEE Directive was implemented differently in each country, accordingly, if you wish
to dispose of this appliance we suggest contacting your local authorities or dealer to find out
what the correct method of disposal is.
INFORMATION ON DISPOSAL IN NON-EUROPEAN UNION COUNTRIES
The crossed-out trash or refuse bin symbol is only valid in the European Union: if you wish to
dispose of this appliance in other countries, we suggest contacting your local authorities or
dealer to find out what the correct method of disposal is.
WARNING!
The Manufacturer reserves the right to make changes to the equipment at any time and with-
out prior notice. Printing, translation and reproduction, even partial, of this manual are bound
by the Manufacturer’s authorisation.
Technical information, graphic representations and specifications in this manual are for infor-
mation purposes and cannot be divulged.
This manual is written in Italian. The Manufacturer is not responsible for any transcription or
translation errors.
MAINTENANCE DISPOSAL AFTER END OF LIFE