FALMEC Classic Mimosa 90, Instruction Booklet

Page: 23 / 83

17
LIGHTING
ASSEMBLY AND REPLACEMENT
I
1. LIGHT BULB
To replace the light bulb:
a) Make sure the appliance is disconnected from the mains power supply.
b) Unscrew the support screw A and remove the light cover.
c) Replace the light bulb with the same model as the original (max 25 W, see the markings
near the light).
A
WARNING! Light bulbs with different shapes and power ratings from the original may seri-
ously damage the light compartment.
2. SPOTLIGHT
To replace the lamp for “Round halogen light”:
a) Make sure the appliance is disconnected from the mains power supply.
b) Remove, by levering with a screwdriver, the support ring A for the cover glass.
c) Remove the cover glass B to access the light compartment.
d) Replace the lamp with the same type (halogen, max 20 W, 12 Volt, G4 fitting).
e) Replace the glass cover B and fasten it using the special ring A.
Round halogen light
How to replace a square halogen light:
a) Check that the equipment is disconnected from the power supply.
b)
Open the panel completely till 90° (see figure) pressing the PUSH button
c) Replace the lamp with a similar one (halogen, max 20 W, 12 Volt, G4 connection).
d) Close the panel. If the panel does not close correctly repeat the operation at point b.
English