Faller 140420, Manual

Page: 37 / 40

CV Explanation Voreinst. Wertebereich
7 Software-Version 5 -
8 Manufacturercode 85 -
47 Adresse HighByte 0 1-255
48 Adresse LowByte Adresse = CV114*256 + CV115 1 1-255
49 Configuration: 0 1-255
Bit 7 0=DCC 1=Mot
50 Start speed 15 1-255
51 Maximum speed 100 1-255
54 Stop speed 18 1-255
55 Number of drives 2 1-255
95 Waiting time when switch is closed 0 0-255
The data format for digital operation and digital operation mode is saved in the CV49.
To CV49:
DCC: Operation modes: with automatic CV49=0
without automatic CV49=1
Motorola: Operation modes: with automatic CV49=128
without automatic CV49=129
Note to CV49:
Do not use any other values! If the CV49 was programmed to 128 or 129,
the controls now only react to the Motorola data format and can only be put back
in DCC mode by means of key programming.
General note:
All CVs are only programmable with a DCC digital centre at the programming track output.
Note re. CV8:
If any random value is programmed in the CV8, all CVs will be reset back to the factory setting.
Operation:
Digital operation:
-----------------------
Digital mode 1: (CV49-Bit0=0)
The start can be performed via the coil item address after that address has been given the status
»green«. All operating sequences will then be those of a start triggered using the start button.
Sound outputs:
Sound output 1 is activated for 0.5 s as soon as the swing is made to start.
Sound output 2 can be activated using CV60, CV61 or CV62.
The CVs hold the number of swinging motions of maximum amplitude counted right from the start.
If the CV holds the value 0, the sound output will not be activated.
Key programming:
-------------------------
The programming key cannot be used unless the attraction is at rest (swing in its lowest position, reed
sensor closed)!
1) Press the key -> the LED flashes 3 x
2) Now actuate some points on a Motorola control unit: the LED flashes 3 x and the address has been
adopted. The control unit displays the Motorola data format.
If a DCC capable control unit is used:
3) Press the key again -> the LED flashes 3 x
4) Now actuate some points on a DCC capable control unit: the LED flashes 3 x and the address has
been adopted. The control unit displays the DCC data format.
If no entry has to be made:
5) Press the key again -> the LED flashes 3 x. The control unit is in the working mode again.
Important:
--------------
If key programming was used to set the control unit to Motorola data format, it cannot be read and
programmed via a DCC capable programming track.
If the control unit has to be set back again from Motorola data format to DCC data format, it must first
be set to the DCC mode through key programming.
Protection of motor power stage and stop outputs:
-------------------------------------------------------------------
The LED flashes rapidly -> Short-circuit at motor output.
The power stage switches off and the processor performs a reset after a few seconds.
37