4
FOR LOCK LESS CYLINDER ONLY
INSTALL OUTSIDE CYLINDER
(Skip if cylinder is already installed)
For all cylinders, rotate the keycam driver clockwise.
All functions
EXCEPT TA571
Insert flat screwdriver
into cam and rotate
clockwise until it stops.
TA571 Function ONLY
Insert flat screwdriver into cam and
rotate clockwise until it stops.
For
KIL cylinder
, rotate
counterclockwise slightly, or
For
IC cylinder
, rotate
counterclockwise
until keycam is at
45 degree angle.
Follow steps below for applicable cylinder type.
KIL (Key-in-Lever) Cylinder
6a Place the cylinder
assembly into the lever.
Insert the key and rotate
90 degrees clockwise.
90° clockwise
6b With key still rotated 90 degrees clockwise, push outside
lever onto the spindle.
Be sure to engage the lever catch.
Cylinder spacer must be installed on spindle.
Lever catch
Cylinder spacer
6c Rotate the key counterclockwise to starting position and
remove it from the cylinder.
Counterclockwise
IC (Interchangeable Core) Cylinder
6a If the outside lever is not installed, push the lever onto
the spindle. Be sure to engage the lever catch.
Spacer must be installed in the lever for FSIC cylinders.
Lever catch
FSIC
Cylinder
spacer
6b Install IC cylinder tailpiece. Push tailpiece until it snaps
into place.
FSIC cylinder:
cap pin
notch
Align notch
with cap
pin.
Note: TA561 and TA575 have
a different cylinder tailpiece.
SFIC cylinder:
6c Insert the control key into
the cylinder and rotate
15 degrees clockwise.
Then, insert the cylinder
assembly into the lever.
15° clockwise
Control key
6d Rotate the key
counterclockwise
until it stops and
remove the key from
the cylinder.
