NATURAL PROPANE
G1528(P)
Main Burner
X - Lighter
Amal 250
R'shaw 22
Amal 90
R' shaw 16
G1518(P) Main Burner Amal 320
Amal 130
NATURAL
GAS TAP
MANIFOLD
17.5
7
PROPANE
EITHER
37
14.8
BURNER INLET
15
6
TEST POINT
LOCATION
mbar
inches w.g.
Description
No. Off
Bench Leg
4
Leg Bolt (M8 x 30)
4
Grill Fixing Screw (M6 x 20)
12
Washer (M8)
4
Spring Washer (M6)
12
KEY TO FIXING DIMENSIONS (mm)
Model
A
X
Y
Z
G1518 (P) 580
150
52
385
G1528 (P) 786
150
52
385
1.8 INJECTOR SIZES -
NATURAL and PROPANE GAS
1.9 GAS PRESSURE
A spring-loaded governor with Rc
1
/
2
(
1
/
2
" BSP)
connection is supplied as a loose item. This must
be fitted to NATURAL gas appliances ONLY.
A governor is not required on PROPANE models.
A pressure test point is located on the tap manifold
and may be accessed by removing the control panel.
Another pressure test point is located in close
proximity to the burner injectors at the rear of the unit.
1.10 BURNER ADJUSTMENTS
1.10.1 To Adjust
a) Fit a suitable pressure gauge to the test point and
light the grill. Consult the User's Instructions for the
lighting procedure.
b) With BOTH BURNERS at the FULL FLAME
position, adjust the pressure if necessary. The
values may be located in Section 1.9.
c) Check that all burner ports cross light satisfactorily.
d) Turn the control to the LOW FLAME position and
check that the flame intensity reduces.
1.10.2 Low Flame Setting
The gas control is provided with a LOW FLAME
setting. Check that this functions satisfactorily. In the
event of adjustment being necessary, follow the
procedure in section 3.6.2.
1.11 FLAME FAILURE
THERMOCOUPLE POSITION
The thermocouple sensing tip should be mounted
5mm below the burner plaques for robust operation.
SECTION 2 - ASSEMBLY and
COMMISSIONING
2.1 UNPACKING
2.1.1 Grill Unit
Unpack the unit and check that all components are
undamaged. Parts supplied loose (1 off each) are as
specified in the contents list below. -
Brander Drip Plate
Brander Plate
Wire Plate
Drip Tray
Gas Governor (Natural Gas Only)
Appliance Mounting Accessories
The mounting method will have been decided at the
time of ordering. The option chosen will be supplied in
a separate pack or carton.
GRILL MOUNTING CHECK LISTS
Important Note
When mounting the grill on bench legs, the placement
surface should be constructed of a non-combustible
material.
2.1.2 Bench Leg Assembly Instructions
Bench legs are fitted to the grill underside using the
fixings provided. It is recommended that these be
fitted when commencing assembly. This operation is
best facilitated by placing the unit on its back.
The kit comprises the following parts -
Each leg is fixed by three M6 screws to
the grill underside. It may then be
positioned and secured to the bench or
worktop with an M8 bolt fed from
beneath the desired surface into the
threaded leg boss.
X
Y
Z
A
