Falcon Professional + FX, User'S Manual & Installation Instructions

Page: 38 / 48

WARNING – SERVICING TO BE CARRIED OUT ONLY BY AN AUTHORISED PERSON
Disconnect from electricity and gas before servicing. Check appliance is safe when you have finished.
34
ArtNo.281-0148
- USA Oven Fan
ArtNo.281-0149 - Fan oven inner ArtNo.281-0149 - Fan oven inner
ArtNo.281-0116 - Oven Thermostat Phial
Phial
4. To change the oven multi-function switch
Move the cooker away from the wall to allow access to the
rear.
Remove the pan supports and burner heads. Remove the
control panel (
Fig. 10.1
) and hotplate (
Fig. 10.4
).
Remove the fixing screws from the front of the oven multi-
function switch. Disconnect the leads and remove the switch.
Fit the new switch.
4. Ovens
1. To replace an oven thermostat
DISCONNECT FROM THE ELECTRICITY SUPPLY.
NOTE:
There are 2 thermostats in the oven. One is the
primary thermostat, which controls the oven temperature
and can be adjusted by the customer using the control knob.
The other is the protection thermostat to prevent the oven
overheating should the primary oven thermostat fail.
The protect thermostat only operates if the primary
thermostat has failed.
To Change the Primary Thermostat
Remove the control panel (
Fig. 10.1 ) and hotplate ( Fig. 10.4 ).
Remove the oven shelves.
Undo the cooker rear cover screws and covers.
Track the route of the thermostat capillary from the rear of
the control on the fascia to where it disappears into the oven.
By moving the capillary it will become obvious which of the
2 phials in the oven it is connected to (
Fig. 10.5
). The phial
can be removed by loosening the p-clips.
Feed the thermostat capillary out and clear of the oven,
noting the routing.
Remove the 2 screws fixing the thermostat to the inner
control panel and disconnect the wiring from the thermostat.
Fit the replacement in reverse order.
Make sure the phial is clipped securely to the oven rear cover.
2. To change the protect thermostat
Follow the same procedure as above except that the control
is situated on the rear cover.
3. To remove the oven inner backs
DISCONNECT FROM THE ELECTRICITY SUPPLY.
Open the oven door. For the right-hand side unscrew the 4
thermostat phial fixing screws.
Remove the fixings that secure the inner back to the oven
rear (
Fig. 10.6
). Lift the removable panels away.
Re-assemble in reverse order. Make sure that the retaining
fixings are fully tightened.
Phial
Fig. 10.5
Fig. 10.6
Fig. 10.7