![background image](http://html.mh-extra.com/html/falcon/mercury-1000-induction/mercury-1000-induction_users-manual-and-installation-instructions_539780020.webp)
16
1
2
3
‘Cook & Clean’ Panels
The ovens have side ‘Cook & Clean’ panels which have been
coated with a special enamel that partly cleans itself. This
does not stop all marks on the lining, but helps to reduce the
amount of manual cleaning needed.
These panels work better above 200 °C. If you do most of your
cooking below this temperature, occasionally remove the
panels and wipe with a lint free cloth and hot soapy water.
The panels should then be dried and replaced and the oven
heated at 200 °C for about one hour. This will make sure that
the panels are working effectively.
n
n
DO NOT use steel wool (or any other materials that
will scratch the surface).
n
n
DO NOT use oven cleaning pads.
The Oven Shelf Supports
The shelf supports on the oven sides can be removed for
cleaning.
To Remove and Refit the Shelves
The shelf has a small kink on either side. To remove the shelf,
line these up with the stops in the shelf support. Lift the shelf
upwards so that it will pass over the shelf stop and then pull
it forwards.
Refit in the reverse order, making sure to push it fully back.
To Remove and Refit the Telescopic Shelf and Runners
Slide the shelf out on the runners. While holding one of the
runners securely, carefully lift the rear of the shelf upwards:
the shelf will spring clear of the central restraining tab. Repeat
for the opposite side of the shelf.
Note:
To aid the removal of the shelf you can insert a suitable
flat tool through the opening in the side of the runners and
lever the shelf clear
(Fig.5-6)
.
Tilt the front of the shelf downwards and then lift clear of the
runners
(Fig.5-7)
.
Refit in the reverse order, making sure to push the shelf down
onto the runner arms.
To Remove and Refit the Ladder Shelf Supports
Lift the ladder support hooks out of the two locating holes in
the oven side (or divider) before lifting the support clear of
the bottom ladder restraint
(Fig.5-8)
.
Refit by inserting the bottom of the ladder into the restraint
before fitting the hooks through the locating holes
(Fig.5-9)
.
The Tall Oven
To clean the oven sides, slide out the shelves, unhook the
supports from the oven sides and lift out
(Fig.5-10)
.
Fig.5-6
Fig.5-7
Fig.5-8
Fig.5-9
ArtNo.320-0022 Tall oven side support
Fig.5-10
Summary of Contents for Mercury 1000 Induction
Page 1: ...Mercury 1000 Induction USER GUIDE INSTALLATION INSTRUCTIONS ...
Page 4: ...ii ...
Page 34: ...30 ...
Page 35: ...31 ...