The use of flammable solvents must be avoided.
Take care not to damage thermostat boss or tubes
located within stainless steel guards when cleaning.
These are secured to pan base.
NEVER SEARCH FOR A GAS ESCAPE WITH A NAKED
FLAME.
Service
Recommended service frequency - 1 Year.
Contact Serviceline, details on title page of this manual.
SECTION 5 - SPARE PARTS
The following parts may require replacing during the life
of this appliance.
Safety thermostat
Spark igniter
Spark ignition electrode
Operating thermostat
Multifunctional control
(MFC)
Thermocouple c/w interrupter
Thermopile
Pilot assembly
SECTION 4 -
CLEANING and MAINTENANCE
Shutting Down after Work
When work is completed, return control knob to pilot
position
(See Figure 1)
leaving pilot lit if required.
Do not use thermostat knob as a gas control.
Burner will re-light when temperature drops below dial
setting. Before draining, allow water to cool. Burner con-
trol should be OFF to avoid accidental operation.
Daily Cleaning
Isolate gas supply and allow pan contents to cool to a
safe temperature. Insert drain pipe supplied into drain
valve. Open valve and drain water into receptacle.
Close valve and wipe down stainless steel exterior
panels with a cloth, wrung out in hot water and detergent.
Rinse with clean water and dry thoroughly.
Weekly Cleaning
Carry out normal daily cleaning procedure. Remove any
accessories and clean seperately. Fill pan with low
sudsing detergent and hot water, just above normal water
level mark. Allow pan to soak overnight if necessary.
Drain detergent water away. Rinse pan thoroughly with
clean, hot water before wiping dry. Reposition any
accessories and refill pan with water.
Stainless Steel Surfaces
Stainless steel can be easily marked by certain types of
scouring pad including nylon types therefore care should
be exercised when using these. Always rub along in grain
direction when rubbing stainless steel with a cloth.
Safety Precautions
Stop valves will be fitted in the water and gas supply
pipes to unit. User must be familiar with device location
and valve operation to enable isolation in event of
emergency.
Warning
Do not attempt to clean with a jet of water or steam clean.
Do not use flammable solvents or cleaning aids.
Acid or halogen based descaling liquids
(e.g. - chlorine)
and cleaning powders should similarly never be used.
If a smell of gas is evident, isolate supply and ventilate
area before calling gas supplier.
