12
“Patent pending, application no. GB 1511389.7”
4.3.1 Before leveling and suiting units ensure the units are fully built, including all
accessories and castings.
4.3.2 Undo the 4 fixing screws on the control panel and remove.
4.3.3 Remove the hob rear infill and replace with rear suiting plate and fixings.
4.3.4 Remove the front side panel countersunk screw and suiting plate.
NOTE: The DLS system is designed to give a quick and easy suiting solution. If you
require an improved seal between appliances we recommend you use, a food grade,
high
temperature silicon sealant.
This can be supplied by Falcon part no
– 523400021
4.3.5 Run a bead of silicon 5 mm from profile edge as highlighted below.
4.3.6 Slide suited units into position.
