At ignition open the primary air control to the maxi-
mum, once the fire has established the primary air
control should be closed to halfway or beyond as is
required to control the heat output, the secondary air
inlet must remain open at all times. Controls may
become hot when the stove is in operation please
use the glove provided.
RECOMMENDED FUELS
All fuels should be stored under cover and kept
as dry as possible prior to use.
This appliance has been tested using seasoned
wood logs. Other fuels are commercially available
and may give similar results. Wood logs up to
370mm long are suitable. All fuels should be stored
under cover and kept as dry as possible prior to use.
Do not use fuels with a Petro-coke ingredient as this
may cause the grate to overheat, causing damage.
Reduced outputs will result when fuels of lower
calorific values are used. Never use gasoline or
gasoline type lantern fuel, kerosene, charcoal lighter
fluid or similar liquids to start or freshen up a fire in
this heater. Keep all such liquid well away from the
heater at all times. Operate the stove only with the
fuelling door closed except for re-fuelling.
WARNING:
Properly installed, vented, operated and main-
tained this stove will not emit fumes into the
dwelling. Occasional fumes from de-ashing and
re-fuelling may occur. However, persistent fume
emission is potentially dangerous and must not be
tolerated. If fume emission does persist, then the
following immediate action should be taken -
(a) Open doors and windows to ventilate room and
then leave the premises.
(b) Let the fire out.
(c) Check for flue or chimney blockage and clean
if required.
(d) Do not attempt to relight the fire until the cause
of the fume emission has been identified and
corrected. If necessary seek expert advice.
The most common cause of fume emission is flue-
way or chimney blockage. For your own safety
these must be kept clean at all times.
14
Fig.20
Fig.20A
AIR CONTROLS
This product has two independent air inlets for
primary and secondary air. The secondary air inlet
is permanently open and is located on the rear of the
stove. The primary air inlet (spin valve) is located on
the door of the stove. Turn the spin valve in an anti-
clockwise direction to open and clockwise to close.
Secondary
Air
Primary
Air
