Falcon DOMINATORPLUS E3865, Design, Installation And Servicing Instructions

Page: 3 / 10

SECTION 1 - INSTALLATION
UNLESS OTHERWISE STATED, PARTS WHICH HAVE BEEN PROTECTED BY THE MANUFACTURER
ARE NOT TO BE ADJUSTED BY THE INSTALLER.
1.1 MODEL NUMBERS, NETT WEIGHTS
and DIMENSIONS
Model
Width
(mm)
Depth
(mm)
Height
(mm)
Weight
(kg)
E3830 Fryer
300 770 890 45
E3860 Fryer
600 770 890 73
E3865 Fryer
600 770 890 85
1.2 SITING
Before connecting appliance to electricity supply, it must
be correctly positioned and levelled. Levelling is effected
by turning the lower area of the adjustable legs.
If desired, feet that allow floor-fixing may be specified at
time of order.
1.3 ELECTRICAL CONNECTION
The unit is designed for use on AC supplies only and
terminals are normally arranged for either 2 phase
operation
(E3830 model) or 3 phase (E3860 & E3865
models) .
If single phase supply has been specified, a bridging link
is provided with the appliance and should be connected
as detailed below.
Cable entry is located at appliance rear in the form of a
cable gland.
A suitably rated isolating switch with contact separation of
at least 3mm in all poles must be installed. All wiring must
be executed in accordance with regulations listed on title
page of this document.
Warning - This appliance must be earthed.
1.4 ELECTRICAL RATINGS
The electrical rating is stated on appliance data plate.
SECTION 2 -
ASSEMBLY and COMMISSIONING
2.1 ASSEMBLY
The appliance is supplied complete and ready to be
connected to the mains supply.
Position unit in desired location and level it. Turn lower
section of each leg clockwise to raise corresponding
corner height or anti-clockwise to lower it.
Castors
Undo grub screw and use a spanner to adjust the castor
height. Turn clockwise to raise level and anti-clockwise
to lower.
Secure grub screw when task is completed.
Grub
screw
2.2 CONNECTION TO THE ELECTRICAL SUPPLY
To gain access to terminals, proceed as follows:-
Remove fixings at unit rear to remove cover and access
electrical connections.
Undo cable gland.
Feed cable through cable gland into electrical box.
Connect leads to respective terminals.
Tighten cable gland.
Replace cover.
If single phase connection is required, refer to Section 1.3
for details.
2.3 COMMISSIONING
Fill pan(s) with oil to mark on element guard
(i.e. approximately 20 litres for E3830 model and 40 litres
for E3860 & E3865 models)
and switch on at isolator
switch. Turn thermostat to maximum setting and
check that it operates at the correct temperature of
190°C.
The importance of never switching on the elements
unless they are covered by oil or water must be stressed.
DO NOT USE SOLID FAT.
2.4 INSTRUCTION TO USER
After installing and commissioning appliance, hand user
instructions to user or purchaser.
Ensure that person (s) responsible is (are) made familiar
with use and maintenance of unit.