Falcon DOMINATORPLUS E3512, Installation And Servicing Instructions

Page: 4 / 6

3.4 RELAY
3.4.1 E3512/E3522 Grills - To Replace
Undo RH side panel fixings and remove panel.
Undo fixings that secure relay to bracket. Remove relay.
Note wire connections/locations and transfer to
corresponding positions on replacement relay.
Secure mounting bracket and replace panels in reverse
order.
3.4.2 E3532 Grill - To Replace
Undo RH outer side panel fixings to remove panel.
Relay can be removed from bracket by undoing fixings.
Note wire connections/locations and transfer wires to
corresponding positions on replacement relay.
Secure to mounting bracket and replace panels in
reverse order.
SECTION 4 - SPARES
and ACCESSORIES
When ordering spare parts, always quote appliance type
and serial number.
This information will be found on data badge attached to
base plate.
SECTION 3 - SERVICING
Before attempting any maintenance, isolate unit at main
switch. Take steps to ensure that it cannot inadvertently
be switched on.
3.1 MAINS INDICATOR LAMP
An indicator neon is located on the control panel and
must be replaced if failure occurs. Undo bottom fixing and
remove panel.
Remove 2 lamp connections. Connect replacement neon
and replace control panel.
3.2 ELEMENTS
3.2.1 E3512 Model
This are fitted with a number of identical elements that
may be replaced individually. To replace a faulty element,
proceed as follows:
Undo back panel fixings and remove panel.
Remove fixings from both sides of element control
bracket, gaining access from front of unit.
Undo fixing that secures element to rear inner panel and
withdraw element.
Fit replacement element and replace additional parts in
reverse order.
3.2.2 E3532 Model
This model is fitted with a single element. To replace a
faulty element, proceed as follows:
Undo fixings on control panel underside and remove.
Remove fixings at top panel rear, front and sides to
remove top panel.
Undo fixings on top front facia and remove.
Remove heat shield above elements. Remove element
connections at terminal posts. Undo fixing that secures
element to RH side panel and withdraw element.
Fit replacement element and replace panels which have
been removed to gain access.
3.3 ENERGY REGULATOR
Remove knob and control panel. Undo screws that
secure regulator to control panel and remove regulator.
Note wire connections/locations and transfer to
corresponding position on control. Fit new control to panel
and replace panel.