Falcon DOMINATORPLUS E3512, Installation And Servicing Instructions

Page: 3 / 6

1.3 ELECTRICAL SUPPLY
Warning
THIS APPLIANCE MUST BE EARTHED
A cable entry suitable for 20mm conduit is situated in the
unit rear at the RH side. To gain access to the terminals,
the RH side panel must be removed.
Mains connection must be made via a suitably rated
isolating switch with a contact separation of at least 3mm
on all poles. The use of heat resistant cable is
recommended. Wiring should be in accordance with
current IEE Wiring Regulations.
Particular attention must be paid to providing adequate
and effective earthing using the earth terminal provided.
1.4 ELECTRICAL LOADINGS
The electrical loading is stated on unit data plate. This is
located on RH outer side panel.
SECTION 2 - ASSEMBLY
2.1 ASSEMBLY
Note
Mounting accessories are available. Contact Falcon
Sales, an equipment distributor or place of purchase.
a) Unpack unit and place it in position using separate
mounting accessories.
b) Mounting accessories should be assembled according
to separate instructions provided.
c) Check the following listed parts are included:-
Brander plate
Brander drip trough
Grid shelf
Grid shelf handles
Drip tray
d) The grid shelf handles are supplied separately and
must be screwed on to grid shelf arms.
1.1 MODEL NUMBERS, NETT WEIGHTS
and DIMENSIONS
1.2 SITING
Installation should be made in accordance with local
and/or national regulations applying at the time and a
competent installer must be employed. There should be
a clearance of 200mm from any wall or object liable to
damage from overheating and 75mm clearance should
be left from any wall to allow removal of the side panels
for maintenance.
In the event of a requirement to position this appliance in
close proximity to a wall, partion, kitchen furniture or
decorative finish, etc. it is recommended that these be
constructed of a non-combustible material. If this is not
possible then these surfaces require to be clad in a
non-combustible, heat insulating material. Close
attention must be paid to fire prevention regulations.
The grill should be installed level and in a well lit position
with adequate ventilation.
Mounting
The grill can be mounted upon:
Floorstand.
Legs: 300mm high.
Wall bracket.
Note
E3532 model is not compatible with old-style plate
shelves.
Model
Width
(mm)
Depth
(mm)
Height
(mm)
Weight
(kg)
E3512 Grill 730 560 505 55
E3532 Grill 785 355 350 30
SECTION 1 - INSTALLATION
UNLESS OTHERWISE STATED, PARTS WHICH HAVE BEEN PROTECTED BY THE MANUFACTURER
ARE NOT TO BE ADJUSTED BY THE INSTALLER.