Falcon Canopy hood, Instruction Manual

Page: 21 / 64

EN
2
1
21
A
Electrical connection and working test
• Before connecting to the mains supply ensure that the mains voltage corresponds with the
voltage on the rating plate inside the hood.
• Connect the cooker hood to the mains via a double pole switch which has 3 mm clearance
between the contacts.
• The appliance must be earthed.
• Once the electrical connection has been completed, check that worktop illumination, motor
and speed work properly.
Ducting or Recirculation fitting
Ducting fitting
• The cooker hood can be ducted to the outside
using either rigid or flexible fire retardant
ducting of 120 or 150 mm.
The choice is left to the installer. When 120
mm ducting is to be used it will be necessary
to install the reduction flange
item A on the air outlet (fig.6).
• Connect the rigid or flexible ducting (which
must be fastened using suitable pipe connec-
tors, not provided) to the reduction flange A
and to the external evacuation ducting (fig. 7).
Suitable material for the above operation must
be obtained by the installer.
Recirculation fitting
• When the hood is installed in the recirculation
mode, the air is recirculated into the kitchen
through the two venting grilles G located on
either side of the lower U-shaped chimney I.
• Connect the additional spigot P to the round
fan outlet, pushing it downwards, and fit spi-
got F to additional spigot P in a similar man-
ner (make sure that the two additional side re-
circulation spigots F1 are fitted to spigot F ).
Make sure that the height of the assembly F+P
corresponds to the height of the chimney out-
let (fig.8).
• Fit the recirculation spigot item F into the
round outlet on top of the canopy while press-
ing down on the spigot until it snaps into posi-
tion (make sure that the two additional side re-
circulation spigots F1 are fitted to spigot F)
(fig.9).
• Install the charcoal filters inside the canopy as
instructed in paragraph Maintenance. Nota:
The two venting grilles must not be fitted into
the chimney stack until the chimney stack has
been installed onto the wall above the canopy.
A32_06
F
F1
F1
F
F1
F1
P
Fig.6
Fig.7
Fig.8
Fig.9