WARNING - SERVICING TO BE CARRIED OUT ONLY BY AN AUTHORISED PERSON
Disconnect from electricity supply before servicing. Check appliance is safe when you have finished.
Page 26
SECTION 2 - ASSEMBLY and
COMMISSIONING
2.1
ASSEMBLY
After unpacking unit, check following parts -
Part
No. Off
Oven Shelves
4
Grill Pan and Grid
I
Ceramic Hob Scraper
1
Roasting Tin with Trivet
2
Cake Rack
2
Handy Rack
1
User’s Manual
1
2.2 CONNECTION TO THE ELECTRICITY SUPPLY
Refer to Section 1.3 of this manual.
2.4 PRE-COMMISSIONING CHECK
Check hob elements in turn. Turn control knob to full on
position and leave hob for a few seconds before checking
that heat is radiating from the element.
When check is complete, turn control off and repeat this
procedure for the remaining elements. Check also that
the residual heat indicator remains lit until the corre-
sponding element cools.
SECTION 3 - SERVICING
3.1 SERVICING
Disconnect from electricity supply before commencing
servicing, particularly before removing any of the follow-
ing:- control panel, side panels, ceramic hob or any
electrical components or covers.
Before restoring power, make connection checks as de-
tailed in Section 1.3. Note - References to LH and RH
oven apply as viewed from the front.
3.2
TO REMOVE CONTROL PANEL
Disconnect appliance from electricity supply.
a) Remove control knobs from all taps.
b) Open grill and RH oven doors. Remove 3 fixings on top
front and 3 fixings on control panel underside.
c) Pull control panel forward. Remove connections from
rear of three neons. Disconnect earth lead and lift panel
clear of unit.
d) Replace all parts in reverse order.
e) When replacing any electrical connections refer to the
wiring diagram on Pages 16 and 17.
3.3
TO REMOVE CERAMIC HOB
Disconnect appliance from electricity supply. Pull unit forward
to gain access.
The ceramic hob material is much more sensitive to
scratches on the underside than the top.
Take care not to touch or scratch the underside of
the ceramic as this will weaken the material and
cause the top to shatter.
a) Remove control panel as detailed in Section 3.2.
b) Remove fixing screws on hob underside (2 - front, 4 -
rear).
c) Lift rear and slide ceramic hob forward.
d) Lift ceramic hob clear of appliance taking care not to
damage elements.
e) Replace in reverse order.
3.4
TO REMOVE AN OUTER SIDE PANEL
Disconnect the appliance from the electricity supply.
a) Remove control panel as detailed in Section 3.2.
b) Remove retaining screw on upper front edge and two
fixings on rear of the side panel. Undo lower retaining
screw situated below the edge at panel front corner.
c) Remove panel by pulling it away from unit. If this is diffi-
cult, it may be necessary to slacken the two closest hob
fixing screws
d) Replace parts in reverse order.
3.5
TO REMOVE A RESIDUAL HEAT
INDICATOR
Disconnect appliance from electricity supply.
a) Remove control panel as detailed in Section 3.2.
b) Remove ceramic hob as detailed in Section 3.3.
c) Disconnect the indicator leads.
d) Remove indicator from bracket.
c) Replace all parts in reverse order.
Ensure replacement indicator functions correctly.
