WARNING - SERVICING TO BE CARRIED OUT ONLY BY AN AUTHORISED PERSON
Disconnect from electricity supply before servicing. Check appliance is safe when you have finished.
Page 24
Installation and
Servicing Instructions
This appliance must be installed and serviced by a
competent person.
IMPORTANT
The unit shall be installed in accordance with the regulations
in force at the time. Read the instructions thoroughly before in-
stallation and subsequent use.
In the UK, regulations and standards are as follows -
BS 6891 :1988
Health And Safety At Work etc. Act
BS 7671 I.E.E. Regulations for Electrical Installations
Local and National Building Regulations
Electricity at Work Regulations
Fire Precautions Act
The appliance has been CE-marked on the basis of compli-
ance with the Low
Voltage and EMC directives for the voltage stated on the data
plate.
WARNING - ALL APPLIANCES MUST BE EARTHED
On completion of the installation, this manual should be left
with the Engineer-in-Charge for reference during servicing.
Further to this, The Users Manual should be handed over to
the Owner, having had a demonstration of the operation and
cleaning of the unit.
IT IS IMPORTANT THAT THESE INSTRUCTIONS BE
CONSULTED PRIOR TO INSTALLING AND COMMIS-
SIONING THIS APPLIANCE.
FAILURE TO COMPLY WITH THE SPECIFIED PROCE-
DURES MAY RESULT IN DAMAGE OR THE NEED
FOR A SERVICE CALL.
SECTION 1 - INSTALLATION
UNLESS OTHERWISE STATED, PARTS WHICH HAVE
BEEN PROTECTED BY THE MANUFACTURER ARE
NOT TO BE ADJUSTED BY THE INSTALLER.
1.1 MODEL NUMBERS, NETT WEIGHTS AND
DIMENSIONS
Model
Width
Depth
Height
Weight
211-EEO
1100mm 600mm
935mm
140kg
1.2 SITING
1.2.1 Positioning the Appliance (see Figure 1)
Figure 1
The unit is supplied with two rear and one centre front roller for
movement purposes.
To position the range, first remove the kicking strip from the bot-
tom front of the unit. Pull open the drawer to the furthest point
and lift and pull it forward to remove. The screw that lowers the
front roller is positioned at the LH side of the drawer opening on
the centre support beam.
Place the flat end of the spanner over the square drive peg and
turn this clockwise until the front beam and feet are clear of the
floor. Use the hex end of the spanner to turn the two adjusting
nuts, positioned at either bottom front corner. Six complete turns
clockwise will lower the back rollers and raise the unit rear.
The unit may now be pushed into position.
THE APPLIANCE MUST NOT BE PUSHED, PULLED OR
LIFTED BY THE TOWEL RAIL OR DOOR HANDLES.