2.
Next take the 38" adhesive Velcro strips and run it down the back of the roll cage facing
towards the rear of the vehicle. Start at the bottom and work your way up the bar. You
will see the double-sided Velcro tabs sewn along the back of the doors. See photo below.
3.
Once all the Velcro is in place the last thing to do is install the screw snap studs. NOTE:
The best way to install the snap studs is to put them in the sockets in the door first.
Then push them into the plastic to make an mark. Then pull the screw stud out and
screw it into the plastic where the mark was made. See Photos Below.