19.
Now place the top over the entire vehicle, the front of the top is identified by the sides being more
steeply curved, and begin by lacing the front straps through the ladder lock buckles sewn to the front
corners of the top. Diagram below shows how to use ladder buckle.
20.
Now run those straps up and through the ladder lock buckles sewn to the rear of the top. You now need
to tighten and loosen the strap of the top so that it is centered correctly.
Cleaning and Storage Recommendations:
1.
Before removing the Cab for storage, make sure it is very clean in order to prevent scratching of the
window panels. Clean with a soft rag or sponge using a mild liquid detergent soap and warm water
solution. Never rub the windows with a dry cloth or rag! Let the Cab dry thoroughly before attempting
to roll for storage.
2.
It is important that the Cab be rolled up for storage rather than folding. Folding will cause damage to
the windows!!! Carefully roll up the Cab similar to the way it was when it was packed at the factory.
On a large, clean and flat surface, fold the doors over the rear panel first, then, interleave the top and
windshield on top of the doors. Begin rolling the Cab into a roll approximately 8 inches in diameter.
Put the rolled Cab back into the carton for storage at a normal room temperature. It is best not to expose
the Cab to either extreme hot or cold temperatures when storing.
3.
A special cleaner conditioner is available from Falcon Ridge that will greatly increase the service life of
the Cab Enclosure. In addition, if additional hook and loop sets are needed, they can also be ordered.
Thank you for your purchase!
