5.
Once all the Velcro is attached securely take the snap studs and screw them into the plastic doors.
NOTE:
It helps to put the snap studs into the sockets in the canvas first. Then one at a time push
the screw into the plastic hard enough so that a mark is left behind. Pull the snap stud back out of
the door and screw it into the plastic where the mark was made. snap the door in place and move
on to the next one
. See photo below.
6.
To use door simply unzip it and pull down on it to release the magnets then reach in and open the plastic
door. Once in lift door up so the magnets attach to the bar and zip closed.
MIDDLE REAR WINDOW:
7.
Begin by placing the 47" adhesive Velcro strips across the top of the roll cage. Make sure to place it on
top of the bar. Photo below shows how it should look.
